Fired Up!

Working with my LASER engraver for a couple of days. Thought I would show off what I have been doing. The lead [photo is a Chevy Corvette C6, My neighbor has both a C6 and just acquired a C7. I gave his this engraving

Only used my LASER for cutting thin paper. I bought a stack of 3mm plywood with the intent I could do some cutting. YES! It does work. 5.5 watts will cut in the first pass if I travel very slow. I prefer to travel faster and make two passes.

Not quoting any speeds and feeds but I am using 100% output. Feed speed will control the depth of cut.

The following is a sample of some of what I have been burning the last few days. I am always amazed at the level of detail available.

Leave a Comment

Your email address will not be published.

This site uses Akismet to reduce spam. Learn how your comment data is processed.